What should I do if the computer chassis case becomes hot, the computer case case manufacturer will explain to you.

The fan may not be able to dissipate heat well when it is running. The fan may not be able to achieve the original heat dissipation function due to the long-term dust deposition.
There are many reasons for the heat in the chassis, not only the CPU, but also other equipment should be well dissipated. For example: power supply, memory, hard drive and graphics card. These are all heaters.

1. It is recommended to clean the dust on the cpu and gpu fans after disassembly; remove the power supply and blow the dust out of the power supply with a hair dryer.

2. Check the air ducts after new installation to see if any fans will disturb the airflow. If turbulence occurs, consider replacing it with a heat pipe radiator.

​

3. Do not overclock at will, this will increase the heat dissipation of the CPU and memory.

Advice, if conditions permit, or if you are rebuilding your computer, please pay attention:

Please choose a tower case, the large space in the case is conducive to the normal flow of the air duct. The fan of the CPU must not be cheap, and the fan of the big heat generator should not be sloppy. The memory needs to be equipped with a heat sink. Today's systems and games take up a lot of physical memory, and memory cooling is necessary.

The hard disk needs to be equipped with a heat dissipation box. Due to the increasing capacity of the hard disk, the number of times of repeated reading and writing is frequent, and the heat generation will naturally be large. The power supply should be a large fan, and many small fan power supplies cannot export the hot air normally. Do not use the graphics card from a small manufacturer. The GPU of a small manufacturer is overclocked, the fan is rough, and there are potential safety hazards. It is better to buy the low-end of the big manufacturer than the high-end of the small manufacturer.